Climax SHARK FIN DEFENDER, Руководство по эксплуатации

Страница: 29 / 62

P/N 97475, Rev. 2 Page 17
4 OPERATION
IN THIS CHAPTER:
4.1 P
RE
-
OPERATION CHECKS
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -17
4.2 O
PERATION
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -17
4.2.1 S
TARTING THE MACHINE
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -17
4.2.2 S
TOPPING THE MACHINE
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -18
4.2.3 E
MERGENCY SHUTDOWN
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -18
4.2.4 A
DJUSTING THE MACHINE SETTINGS
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -18
4.3 D
ISASSEMBLY
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -18
4.1 P
RE
-
OPERATION CHECKS
Do the following checks before operating the machine:
1. Complete the risk assessment checklist in Table 1-3 on page 5.
2. Check that the work area is clear of non-essential personnel and equipment.
3. Check that the machine control/observation area will not be in the path of
hot flying chips during machine operation.
4. Check that the machine is securely mounted to the workpiece.
5. Check that air hoses are routed and secured to avoid tripping, entangle-
ment, damage from hot chips, or other damage should an air hose or con-
nection fail.
6. Check the tool condition and sharpness.
7. On the PCU, check that the oil drip rate is set to 6 drips per minute.
8. Check that all hand tools are removed from inside the machine and the
work area.
4.2 O
PERATION
WARNING
Do not leave machine unattended during operation. Unattended
machines could cause damage or serious personnel injury.
4.2.1 Starting the machine
Do the following to operate the machine after the setup steps are complete (see
Figure 2-1 on page 10 and Figure 2-2 on page 11):
1. Push the
START
button on the operator pendant.
2. Use the motor speed control on the PCU to turn on the drive motor and to
adjust the drive motor speed to achieve the desired rotation rate.