Climax SHARK FIN DEFENDER, Руководство по эксплуатации

Страница: 30 / 62

Page 18 Defender Clamshell Operating Manual
3. Use the
TRIPPER
switch as required to feed the tool slide and advance the
cut (see Section 4.2.4).
4.2.2 Stopping the machine
Do the following to stop the machine (see Figure 2-1 on page 10 and Figure 2-2 on
page 11):
1. Set the
TRIPPER
switch to the off position.
2. Turn the motor speed control to zero so that the machine stops rotating.
3. Press the
E
-
STOP
button to prevent accidental restart of the machine.
T
IP
:
When the cut is complete, the best practice is to first stop the
feed and then stop the machine rotation.
4.2.3 Emergency shutdown
To stop machine operation immediately, press the
E
-
STOP
button on the operator
pendant (see Figure 2-1 on page 10).
Before restarting the Defender™, do the following:
1. Close the speed adjustment valve on the PCU.
2. Twist and pull the
E
-
STOP
button up.
3. Press the
START
button (repeat step 1 if necessary).
4.2.4 Adjusting the machine settings
During machining, the diameter of the cut may be adjusted by engaging the
TRIP
-
PER
switch (see Figure 2-1 on page 10).
This engages the tripper, which then turns the star wheel as the tool slide passes.
Then the cutting tool advances.
See the Clamshell Machine operating manual (P/N 97521) for details on feeding
the tools.
4.3 D
ISASSEMBLY
Do the following to disassemble the Defender™:
1. Disconnect pneumatic cables.
2. Remove the guards and replace the original clamshell screws (see Section
3.2 on page 13).
For more detailed instructions, follow the assembly instructions in Section 3.2 on
page 13 in reverse.