Climax FF4000, Руководство по эксплуатации

Страница: 20 / 50

Page 12 FF4000 Operating Manual
Setting tool bits
Facing head
•
Select and install a suitable tool bit into the tool head.
•
Tighten the setscrews.
•
For production jobs, set and test the settings on a test work piece.
Beveling head
•
Select the tool bit, or combination of bits, and slip them into the tool head.
•
Position the tool bits to cut the entire area required.
•
Tool bits are installed in a set order to achieve the required bevel
configuration. Inside diameter bits are set first, facing or squaring bits next,
and outside diameter or j-groove bits last.
•
With each tool bit correctly in place, tighten the setscrews.
•
When a land is required on the work piece, use a facing bit in combination
with the beveling bit. The FF4000 beveling head can plunge cut, but does not
feed in a radial direction. The width of the land is controlled by the position of
the beveling bit or by selecting a bit with a greater or lesser overall height.
•
If a specific ID bevel is called for, set and test the ID bit to ensure correct
sizing. Cut the ID portion of the bevel first.
•
For production jobs, set and test tool bit settings on a test piece of tube or
pipe.