Climax FF4000, Руководство по эксплуатации

Страница: 25 / 50

P/N 35425, Rev. 2 Page 17
Operation
Pre-start checks
CAUTION
To prevent serious bodily injury from moving
machinery, turn off and disconnect the air supply
before performing pre-start checks.
•
Be sure tool bits are sharp.
•
Check that moving parts move freely.
•
Fill the air lubricator with air oil that includes antioxidants and rust inhibitors
such as Mobil ALMO525.
•
Adjust the lubricator to deliver oil at a rate of 15-20 drops per minute.
•
Drain all liquid and remove dirt from the air filter.
•
Close the ball valve.
•
Check that the in-line air pressure is 90 psi (620 kPa).
Facing
NOTE
For precision facing operations, it is good practice to lock the feed by
tightening the set screws under the feed handle.
•
Be sure the air supply is disconnected and turned off.
•
Secure the tool bit in the facing head.
•
Position the facing head cutting depth using the feed handle.
•
Lightly tighten the 3 set screws under the feed handle to stabilize the mandrel
and reduce the chance of chatter.