Climax BB8100, Руководство по эксплуатации Оригинальные инструкции

Страница: 27 / 112

P/N 57064, Rev. 5 Page 17
WARNING
Swinging or falling machinery can seriously injure the
operator. Securely wrap the hoist around the bar and
bearings before lifting the machine.
6. If using existing holes on your workpiece, make sure they align with the slots
in the spider. Tap 5/8" (0.63 mm) or 1/2" (13 mm) new holes if necessary.
If holes are to be tapped, hold the spider against the work piece and mark the
locations of the slots in the spiders.
7. Pull the bearing assemblies from the boring bar. Remove the bar from the
workpiece.
8. Mount one bearing assembly to the end of the work piece.
9. Slide the boring bar through one bearing support assembly.
10. If you want to mount the rotational drive assembly between the supports, do it
now. See
the “
Rotational drive assembly setup
”
on page 21 for mounting
information.
11. If mounting another end-mount bearing support assembly, repeat steps #4
through #10. If using an ID-mount bearing support assembly, see t
he “
ID-
mount bearing support assembly setup
” o
n page 18. At least two support
assemblies are needed to ensure machine stability.
12. Slide the boring bar through all bearing assemblies.
13. Lock the bar in place by tightening the tapered lock nut to the bar, screwing
the eight 3/8-24 hex head cap screws against the taper.
Figure 14. Tightening the bearing assemblies to the bar
Bearing mount assembly
Tapered loc k nut
Modified loc k washer
Modified loc k nut
3/8-24 hex head sc rews
tighten the tapered loc k nut
1/4-28 hex head sc rews -
use to loosen loc k nut
.25”