Climax BB8100, Руководство по эксплуатации Оригинальные инструкции

Страница: 31 / 112

P/N 57064, Rev. 5 Page 21
Rotational drive assembly setup
The rotational drive assembly can be placed anywhere on the boring
bar.
CAUTION
The boring bar is not hardened. To prevent damage, do not
strike it against the bearing supports or the work piece.
1. Mount the torque arms to the rotational drive housing
2. Mount the hydraulic motor to the rotational drive housing, if necessary. Check
that the mounting bolts are tight.
3. Loosen the socket-head screws. Push the locking rings out by screwing in
the four socket set screws.
4. Slide the rotational drive assembly along the boring bar.
5. Remove one of the locking rings to gain access to the RDU keyway.
6. Insert the drive key into the boring bar leadscrew groove. Check that the key
meshes with the leadscrew.
7. Slide the key along the groove and into the RDU keyway.
CAUTION
The rotational drive key must be in place before operating
the boring bar. Failure to do so may damage the machine.
8. Replace the locking ring after the key is installed.
9. Lock the rotational drive assembly to the bar by tightening the socket-head
cap screws.
NOTE
Tighten only the eight socket-head cap screws in the locking
rings, not the four setscrews. The setscrews loosen the
locking rings. Back out the setscrews before clamping the
rings to avoid damage to the rings.
Figure 16. Rotational drive
assembly