Climax BB8100, Руководство по эксплуатации Оригинальные инструкции

Страница: 22 / 112

Page 12 BB8100 Operating Manual
ID-mount non self-aligning bearing support assembly (with spider)
The ID-mount bearing support assembly holds the bar in place with a taper locking
adapter. Center the bar by adjusting the four jaws on the spider. The jaws can be adjusted
from outside the bore.
Bearing support assemblies are available for bores with IDs from 23
–
77" (584
–
1,956 mm).
Figure 6. Non-self-aligning ID
mount with spider (20
–
35" 508
–
889 mm)
Figure 7. Non-self-aligning ID
mount with spider (34.25
–
49.25"
870
–
1,251 mm)
Figure 8. Non-self-aligning ID
mount with spider (48.5
–
77"
1,232
–
1,956 mm)
Non self-aligning bearing assembly (without spider)
The bearing assembly does not include a spider; it mounts to any existing support
structure. See Figure 36 on page 57 for mounting dimensions. A taper locking adapter
secures the bar inside the bearing.
Clamp Collars
The clamp collars (P/N 40708) are made in
matching sets and must be used to secure the
bar when the machine is in the vertical
orientation. This will prevent the bar from sliding
through the support bearings or falling.
To prevent over tightening of the bearings, the
clamp collars should be placed above at least
two support bearings in a vertical orientation.
Figure 9. Clamp collar