Clifford BlackJax 5, Руководство по установке

Страница: 14 / 23

www.directed.com
14
rpm/speed programming
N NO OTTEE:: Upon completion of the installation, and if a tach or speed sense connection
has been made, one of the two following programming steps m muusstt be done. The
BlackJax 5 module has the default sense mode set to tach.
The BlackJax 5 is versatile in that it has the ability to work with tachometer, or speed
sense, or no sense connection at all.
In ssppeeeedd sseennssee mode, the ignition will shut off at or below the programmed speed. The
vehicle must be equipped with electronic speed sense.
In ttaacchh sseennssee mode, the ignition will shut off at or below the programmed RPM.
With nnoo ssppeeeedd oorr ttaacchh connection, the ignition will not shut off. Instead, BlackJax 5
will not allow the vehicle to restart once the ignition has been turned off.
RPM programming procedure
N NO OTTEE:: This programming step m muusstt be completed if the tach is connected for the
BlackJax 5 to operate properly.
1. Drive the vehicle to a nearby open area and allow the engine to warm-up until
the RPMs drop to the normal idle speed.
2. With the engine still running, place the transmission in PARK (or NEUTRAL if the
vehicle has a manual transmission).
3. Enter installer-programming mode (with the ignition ON, enter the factory preset
valet code by pressing the
button twice and the button once, then press
and hold the button for 13 seconds). Within the first 3-seconds, you will hear
one chirp. Continue holding the button until you hear three chirps - this
indicates that you are now in installer programming mode. Release the button.
4. Press the button of the PlainView 2 Switch once. After a 3-second pause, the
system will sound one chirp to confirm column one selection (see the
Installer-
Programmable Features
section).
5. Press the button of the PlainView 2 Switch five times (you will hear a chirp
each time you press the button) to select row five. After a 2-second pause, you
will hear two chirps to confirm idle RPM has been set (if you hear just one chirp,
check the connection of the BLACK/GRAY wire, then repeat steps 1–5).
6. Turn the ignition OFF.