Clifford BlackJax 5, Руководство по установке

Страница: 15 / 23

© 2005 directed electronics—all rights reserved
15
speed programming procedure
N NO OTTEE:: This programming step m muusstt be completed if the speed sense setting is used
for the BlackJax 5 to operate properly.
to change read mode from tach to speed
1. Turn the ignition ON.
2. Enter installer programming mode (with the ignition ON, enter the factory preset
valet code by pressing the
button twice and the button once, then press
and hold the button for 13 seconds). Within the first 3-seconds, you will hear
one chirp. Continue holding the button until you hear three chirps - this
indicates that you are now in installer programming mode. Release the button.
3. Press the button of the PlainView 2 Switch once. After a 3-second pause,
the system will sound one chirp to confirm column one selection (see the Installer-
Programmable Features section).
4. Press the button of the PlainView 2 Switch twice (you will hear a chirp each
time you press the button) to select row two. After a 2-second pause, you will
hear one chirp indicating you are now in speed sense mode.
to set speed
1. Determine what the ideal speed will be for the vehicle's ignition to shut off.
2. Drive the vehicle to an open area or a local surface street.
3. Enter installer programming mode (with the ignition ON, enter the factory preset
valet code by pressing the
button twice and the button once, then press
and hold the button for 13 seconds). Within the first 3-seconds, you will hear
one chirp. Continue holding the button until you hear three chirps - this
indicates that you are now in installer programming mode. Release the button.
4. Drive the vehicle to the desired minimum speed you would like the ignition to
shut off when BlackJax 5 initiates.
W WA AR RN NIIN NG G!! There m mu usstt be another technician in the car
to program the MPH while the vehicle is being driven, or
injury or death could result.