Your 4-button/12-channel remote controls
The 4-button/12-channel remote controls are ultra-sophisticated miniature radio
transmitters powered by a tiny 12-volt battery. A weak remote control battery will
reduce range (see page 18 for battery replacement instructions). Electrical interference
and even sunspots can interrupt the signal from your remote control to the system. If
this happens, repeatedly press the remote control button (this is more effective than
holding the button). The 4-button/12-channel remote control is the key to your
system. It has Clifford’s Anti-CodeGrabbing (ACG) technology for the ultimate
protection against “code-grabbing” devices (see page 8). You will use your remote
to arm and disarm the system, lock and unlock the doors, engage and disengage the
AutoImmobilisation circuits, enable/exit valet mode and command options such as a
remote boot release, power window operation and even remote engine starting.
How to use your key chain re mote con trol
Your remote control can individually
command up to 12 different system functions
and options. It’s like having a TV with 12
channels. You change channels (functions)
with your keychain remote control. But
instead of putting 12 buttons on the remote,
we made it easy: First, the button you use
the most — button 1 to arm, disarm, lock and
unlock — is larger than the others. Buttons 2,
3 and 4 are the smaller buttons to the right,
below and left of button 1. The LevelShift
button on the side of the remote control allows you to select channels 5–12:
n
To trans mit ei ther chan nel 1, 2, 3 or 4:
Just press either button 1, 2, 3 or 4. For
instance, to transmit channel 3, press button 3. whilst you transmit, the LED
indicator will blink once every second: this indicates level 1.
n
To trans mit ei ther chan nel 5, 6, 7 or 8:
Press the LevelShift button once. This
shifts buttons 1–4 to level 2 (channels 5–8). Then press the desired button within
the next 7 seconds. For instance, to transmit channel 5, press the LevelShift button
once, then press button 1. whilst you transmit, you’ll notice that the LED indicator
blinks twice, pauses, blinks twice, etc.: this indicates level 2.
n
To trans mit chan nel 9, 10, 11 or 12:
Press the LevelShift button twice. This shifts
buttons 1–4 to level 3 (channels 9–12). Then press the corresponding button within
the next 7 seconds. For instance, to transmit channel 10, press the LevelShift button
twice, then press button 2. whilst you transmit, you’ll notice that the LED blinks
three times, pauses, blinks three times, etc.: this indicates level 3.
NOTE: One second after you stop transmitting level 2 or level 3 (channels 5–12),
the remote control automatically returns to level 1 (channels 1–4).
6
