Notice that you did not have to reselect column 2. If you don’t touch the switch, the
system stays in the column for 10 seconds to allow you to select any other feature(s)
in the same column without having to re-enter the column number. Of course, you
may also toggle the latched side to select a new column. If you wait more than 10
seconds, the system automatically jumps back to the “Feature Select” position.
This is the “standby” position: ready for entry of a new programming selection. If
no action is taken for the next 60 seconds, the system automatically exits program
mode, perfect if you program whilst driving or if you forget to turn off the ignition.
Changing the remote control battery
Your remote control is powered by a small 12-volt battery. As the battery begins to
go flat, range will decrease. Replacement batteries are available at all Authorised
Clifford Dealers and at most other electronics and automotive security shops. To
replace the battery (any Clifford Dealer will be happy to do this for you):
1. Remove the retaining screw and gently pry apart the two halves of the case with your
fingernails near the bottom of the remote (where the keyring is).
2. Note the orientation of the old battery, then replace it with the new battery (+ and –
symbols are also engraved inside the bottom half of the case).
3. Snap the case back together by first aligning the top (where the LED window is),
then retightening (but not over-tightening) the retaining screw.
Adding new remote controls
For other drivers in your family, or if you wish to control Concept 50x systems on
your other cars with the same remote control, you can buy additional remote
controls from any Clifford Dealer (call our UK office on ring on 0800-929949 or
0181-646-8440 for the nearest dealers) and program them into the system yourself.
Each Concept 50x will respond to as many as four 12-channel ACG remote
controls. To add a new remote control to the system, use the procedures noted in the
User-selectable features section on pages 16-20.
How to erase the codes of lost or stolen remote controls
If one of your remote controls is ever lost or stolen, you may erase it from the system
memory to make sure the missing remote control can never be used to disarm your
system. To do so, use the “Erase all channels” feature (column 1, row 5) on the
Table of user-selectable features on pages 19-20). This will clear all remote controls
from the system memory. Then simply program each remaining and/or replacement
remote control as noted in the Adding new remote controls section above.
Mak ing changes to the ex ist ing se cu rity sys tem will in vali date the cer tifi cate of
in stal la tion.
Should any fault with the se cu rity sys tem oc cur, please con tact your in stall ing
Clif ford agent as soon as is con ven ient.
18
