To en able valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Enter your valet code on the PlainView switch, then return the switch to its centre position.
3. You now have 5 seconds to press the latched position to enter valet mode. The
system’s LED will glow continually for ongoing visual confirmation of valet mode.
To exit valet mode
The system will automatically exit valet mode the next time that the ignition switch is
turned to the “ON” position (e.g., when the engine is started).
Be sure to re turn the Plain View switch to its cen tre (neu tral) po si tion. Oth er wise,
the sys tem will auto mati cally in voke the To tal Re call fea ture (see page 14).
Setting your own secret valet code
If you wish to set your own valet code, you may choose any 4-digit code, except one that
begins with a zero (e.g., 3210 is fine, but 0123 will not be accepted). You can also change
your valet code whenever you want. Simply write down the 4-digit code you wish to use,
then refer to the example below and the User-selectable features section on pages 16-20.
Ex am ple
Let’s say you want to set a valet code of 2301. To do so, you would do the following:
1. From the Table of user-selectable features on pages 19 and 20, you would note that
the “set a new secret valet code” feature is in column 3, row 6.
2. Enter program mode by turning on the ignition, entering your current valet code, then
pressing the PlainView switch to its momentary side for 3 seconds until you hear a chirp.
3. Select column 3 by moving the switch between latched and centre 3 times, i.e.:
latched, centre, latched, centre, latched, centre. After a brief pause, you will hear 3
chirps to confirm that you have selected feature column 3.
4. Select row 6 by pressing and releasing the momentary side of the switch 6 times. To
help you count, you will hear a chirp each time you press the momentary side. Then
immediately flip the switch to the latched position.
5. Immediately enter your new code. To enter 2301 as your new code, you would press the
switch in this manner: momentary, momentary, latched, (you’ll hear 2 chirps to confirm
the first digit), momentary, momentary, momentary, latched, (3 chirps to confirm the
second digit), centre, latched (zero chirps), momentary, latched (1 chirp), centre.
6. Wait 3 seconds until you hear 2 chirps, indicating the new code has been accepted.
7. Turn off the ignition to exit program mode (you’ll hear a 3-chirp confirmation).
8. VERY IMPORTANT: You must now test your new secret valet code: Turn on
the ignition, enter your new code, then flip the switch to its latched position. The LED
will illuminate. If it does not, the new code you programmed and the one you just entered
do not match. In such a case, the system will revert to the previous code.
Remote controlled valet mode entry and exit
You can even remotely enable or exit valet mode by transmitting channel 9 (LevelShift
twice, then button 1). In addition to the above indications, two indicator light flashes
confirm remote enabling of valet mode, a single flash confirms exiting. The next time
that the ignition switch is turned to the “ON” position, valet mode is automatically exited.
11
