22
CHARGING BATTERY
Charging the battery incorrectly may cause damage.
Always read the instructions that came with the
battery charger and follow all directions on the
battery.
For home charging, we suggest you use a trickle
charger. A trickle charger can be left connected for a
long period of time without causing damage to the
battery. Do not leave the battery connected to the
charger longer than the recommended amount of
time.
Do not use an automotive battery charger as this can
cause permanent damage to your battery.
BATTERY REPLACEMENT
WARNING:
Batteries contain sulfuric acid. Avoid contact with
skin, eyes, or clothing. Always wear eye protection
with side shields marked to comply with ANSI Z87.1,
along with rubber gloves when working with
batteries. Have water available in case acid comes in
contact with eyes or skin. Keep all children and
bystanders away from the area while this procedure is
being performed. Failure to do so could result in fluids
entering your eyes, burns, and other possible serious
injuries.
POISON -‐ CAUSES
SEVERE BURNS
Contains sulfuric acid. Avoid contact with skin, eyes,
or clothing. To prevent accidents, rinse empty
container with water.
ANTIDOTE:
External -‐ Flush with water
Internal -‐ Call physician immediately. Drink large
quantities of water or milk. Follow with Milk of
Magnesia, beaten eggs, or vegetable oil.
Eyes -‐ Flush with water for 15 minutes and get prompt
medical attention.
NOTE:
If you are unsure if you are qualified to
perform this operation, take the unit to an authorized
service center.
The battery is located inside a chrome battery box
underneath the seat.
Remove the 2 bolts that retain the battery box
cover to obtain access to the battery.
The make sure the positive contact is on the + and
the negative contact is on the -‐.
The vent tube should be inserted through the hole
in the bottom of the box, so the fumes can vent
outside the battery box. Failure to do so will result
in corrosion.
WARNING:
Failure to place battery on a level surface may allow
fluid to seep or spill out of the battery, resulting in
serious personal injury.
Clean the cable connectors with a wire brush or
sandpaper to remove oxidation .
After charging, install new battery with poles facing
forward.
Put dielectric grease on the battery terminals to
avoid corrosion.
Attach red positive (+) cable to the positive (+)
terminal on the battery. Tighten securely.
Attach black negative (-‐) cable to the negative (-‐)
terminal on the battery. Tighten securely.
WARNING:
Always connect the red positive (+) cable first and
then the black negative (-‐) cable. Failure to do so
could cause the battery to explode, causing serious
personal injury.
Securely fasten battery inside the battery box,
making sure the positive terminal does not touch
the side of battery box.
WARNING:
Make sure seat is in proper position and attached
securely when you install it. Failing to install the seat
properly could allow the seat to move and cause the
rider to lose control, resulting in possible serious
personal injuries.
Dispose of the old battery in a manner approved by
applicable regulations.