3 Basis
3.5 Fitting M1 door
\
Figure 1
Figure 2
Detail A
Assembly of top bar
-
Q)
E
::i
E
Cl
C")
+
.....
cii
en
C:
�
ca
:;::::;
a.
ci:i
ci:i
�
Cabin interior
�
Detail B
Door fram
Cementing underside door frame
Frame
Figure 3
1)
Now place the other frames on the door side of the cabin in the same way as the other frames.
Use the corner pieces as described in section 3, figure 2 on page 8.
The 750 or 1000 mm top bar supplied is fitted above the opening for the door depending on the type of door (750 or
1000 mm).
Note: With a cabin with frame height 1900 mm from the floor the top bar is not used. The roof then directly rests on the
top of the door frame.
Check and adjust the height and squareness of the frames (fig.1 ).
Apply polymer cement to the floor where the underside of the door frame is fitted for a good seal.
The floor must be clean.
2)
Fit the door with casing between the frame parts and bring the casing level (fig.2).
Fix the casing to the frame using {glueing) clamps and fasten the casing with self-tapping screws. (fig. 3). One each
side use 3 screws spread along the height of the casing.
SEDNA LINE 2008/05
14
