background image

1

2

N

1 - 2

to drainage

Stone Baths

Waste connection is dependant on the site situation; final decision 
about installation of waste connection should be taken 
by a suitably qualified person.

Under floor access required for plumbing of bath waste.

3

Manufacturers

Identification Number

In the event of after

sales requirements

please quote this

number.

Please place your product

identification number 

here and keep this 

paperwork in a safe 

place as you will 

need this if a problem 

occurs with your product. 

XXXXXXXXXXX

Parts supplied:

1x

4x

         Do NOT overtighten the waste as this may cause long term damage to the bath. We recommend to use a torque wrench to tighten the waste by using 

 

         a torque force between 25 Nm and 50Nm.

Important

Please unwrap the bath and check it carefully to ensure it has not been damaged during handling or transport.

Please check that all parts have been supplied.

 Assemble bath on a mat to protect against damage to the bath surface.

Store the bath in a safe place until you begin installation.

 Any installation should be carried out by a qualified tradesman with knowledge of statutory plumbing requirements in your area.

This installation guide does not include details of waste connection; final decisions about installation of waste connection

should be taken by a suitably qualified person.

Care and Maintenance

The below instruction is for a fine scratch or slight mark on the surface. If the scratch or mark is too deep, then a Clearstone Repair Kit CRK will be necessary. If using the 
Repair Kit, follow the instructions supplied with the Repair Kit. For a fine scratch or a slight mark, use a 1500 grade sand paper, gently sand the area with water. For best 
results, limit sanding to the smallest possible area around the scratch. Re-polish the surface afterwards using a neutral polishing compound or toothpaste. 
It may be possible to polish very fine scratches away without using abrasive papers: scrubbing gently with a soft brush or plastic pad (not metal scouring pad) and a mildly 
abrasive cream cleaner. Afterwards scrub the whole area with plenty of clean water and re-polish as before.

Everyday cleaning

We recommend a non-abrasive bathroom cleaner. 

Warning

Never use cleaners / bleach products, caustic soda and or ethyl alcohol (for example Lysoform or other specifically manufactured WC bowl cleaners. In case of contact 
rinse immediately with water.
Do not drill through the side of the bath for the waste connection, only where the overflow template is provided.  Waste pipe is through floor access only.

Please note that hair dye/colouring or oil based colours may discolour your bath. Avoid using any strong dye or colour in or near your bath.

When using underfloor heating please take care not to put the heating pipes/mats underneath the bath area. The bath should not sit on a heated floor.

Bath mat or suction pad might cause damage to the surface over time and must be avoided. 

Отзывы: