CleaverBrooks ADAC 1000, Руководство по эксплуатации

Страница: 103 / 140

APPENDIX A - Variable Frequency Drive Parameters
Part No. 750-386 A-9
A.2 - PF 400
Note: Set switches AO1 & AO2 to 20mA.
Note: Set switches AI1 & AI2 to 20mA.
Note: Set switch SNK/SRC to SRC.
PowerFlex 400 - ADAC 1000
Par. No. Parameter Name Default Value
Basic Display
b1 Output Freq Read Only
b2 Commanded Freq Read Only
b3 Output Current Read Only
b4 Output Voltage Read Only
b5 DC Bus Voltage Read Only
b6 Drive Status Read Only
b7 Fault 1 Code Read Only
b8 Process Display Read Only
b9 Not Used
b10 Output Power Read Only
b11 Elapsed MWh Read Only
b12 Elapsed Run Time Read Only
b13 Torque Current Read Only
b14 Drive Temp Read Only
b15 Elapsed kWh Read Only
Basic Program
* P31 Motor NP Volts Rated Volts Motor NPL Volts
* P32 Motor NP Hertz 60 Hz Motor NPL Hertz
* P33 Motor OL Current Rated Amps Motor NPL F.L. Amps
P34 Minimum Freq 0.0 Hz OK
P35 Maximum Freq 60 Hz OK
* P36 Start Source 2-W Lvl Sens 2 Wire, 002
P37 Stop Mode Coast,CF OK
* P38 Speed Reference Analog In1 Analog In 2 - 003
* P39 Accel Time 1 20.00 Secs 3 Secs
* P40 Decel Time 1 20.00 Secs 3 Secs
P41 Reset to Defaults Ready/Idle OK 1 = Reset
P42 Auto Mode Hnd-Off-Auto No Funtion - 000
P43 Motor OL Ret Disabled OK
Terminal Block
* T51 Digital In 1 Sel Purge Preset Freq - 008
T52 Digital In 2 Sel Local OK
T53 Digital In 3 Sel Clear Fault OK
T54 Digital In 4 Sel Comm Port OK
T55 Relay Out 1 Sel Ready/Fault OK
T56 Relay Out 1 Level 0.0 OK
T57 Not Used
T58 Relay 1 On Time 0.0 Secs OK
T59 Relay 1 Off Time 0.0 Secs OK
T60 Relay Out 2 Sel MotorRunning OK
T61 Relay Out 2 Level 0.0 OK
T62 Not Used
T63 Relay 2 On Time 0.0 Secs OK
T64 Relay 2 Off Time 0.0 Secs OK
T65 Opto Out Sel At Frequency OK
T66 Opto Out Level 0.0 OK
T67 Not Used