ClearWater Zodiac LM2 Series, Руководство по устранению неисправностей

Страница: 15 / 20

15
Touch Pad PCB
Check / Replace
1 . Turn off power supply .
2 . Remove chlorinator from wall .
3 . Remove 4 screws to remove cover .
4 . Disconnect ribbon wire connector from power PCB (do NOT remove touch pad PCB from cover at this time) . If
interfaced with controller remove communication wire .
5 . Plug ribbon wire connector from new touch pad PCB into power PCB .
6 . While holding edges of touch pad PCB, turn on power supply .
7 . Push buttons and check all light functions .
Are all functions restored?
YES NO
Replace Touch Pad PCB
1. Turn off power supply.
2. Disconnect ribbon wire connector of new touch pad PCB
and set aside.
3. Remove 4 screws to remove touch pad PCB from cover.
4. Attach new touch pad PCB to cover with 4 screws.
5. Attach ribbon wire connector to power PCB. Attach
communication wire if needed.
6. Replace cover with 4 screws.
7. Replace chlorinator on wall.
8. Turn on power supply.
9. Interface if needed.
Note : If unit functions properly after replacing touch pad, power
PCB will NOT need to be replaced .
LM3 Interfacing with Controller: Reconnect wire and follow
Interface Instructions on page 14 .
1. Disconnect ribbon wire connector of new
touch pad PCB and set aside.
2. Replace power PCB.
(see Power PCB pg. 17)
3. Attach original ribbon wire connector to
power PCB.
4. Replace cover with 4 screws.
5. Replace chlorinator on wall.
6. Turn on power supply.
7. Interface if needed.
After initialization for both the controller and the LM3, a software connection should have been made . A valid connection
can be verified by observing the menu screen of the controller being used . If the chlorinator does not appear to have
made a connection, try resetting both the LM3 and the controller .
When connected to a suitable controller the LM3 behaves as a “drone”, responding only to the controller, so NONE of the
buttons on the LM3 will function .
Controller Disconnection
If the communication link between the controller and the LM3 is lost, the LM3 will continue operation as it was before the
controller lost connection . The chlorinator will then behave as a “stand alone” unit until the controller is reconnected or the
user changes the settings .