25
CLEARSPAN
™
POLY BUILDINGS
Revision date: 12.08.15
INSTALL PVC CONDUIT FOR MAIN COVER ENDS
Complete this section
if building is longer than 48'
. The
PVC conduit is inserted into a pocket at each end of the
cover. Strapping is then threaded around the conduit and
end rafters. Finally, strapping is tightened to stretch main
cover end-to-end.
Required parts and tools:
• LJ2842 (3/4" PVC conduit) and 103620 (1" strap)
• Duct tape, Tek screws, and driver for Tek screws
• Tool to cut strap, a lift or ladders to reach top of frame,
and assistants to install and tighten strap
Photo shows stretch pocket and conduit and strapping as
installed for a similar cover. View shows cover as seen
when standing inside the building looking up at end rafter.
Main
Cover
PVC Conduit
Strap
End Rafter
Notched
Stretch
Hem Pocket
Install PVC conduits near main cover ends to provide an
additional tie-down position. Complete these steps to install
conduit and strapping for main cover stretch pockets.
1. Take first section of PVC conduit and feed into stretch
pocket from bottom at one end of cover.
Insert plain
end of conduit into pocket so next section can be joined
to the first.
2. Once the bell end reaches the pocket, take another
section of PVC conduit, insert the plain end into the bell
end of the previous section and secure the joint using
customer-supplied PVC glue
.
NOTE:
Wrap joint using duct tape. Photo shows
conduit inside stretch pocket on inside surface of cover.
Apply PVC glue to
belled end of conduit.
