Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 71 / 168

Vitec Group Communications
CellCom-10 Instruction Manual 5 - 1 5
Figure 5-23: IP Address Menu
The IP address may be changed by use of the Enter/Setup rotary
encoder. The current part of the IP address that will be changed is
highlighted and slowly rotating the encoder increases the IP address in
increments of 1 per step whilst rapidly rotating the encoder increases
the IP address in increments of 10 per step. When the required value
is set press the encoder to confirm it and then rotate the encoder one
step to select the next part of the IP address and repeat the procedure.
When the required IP address has been set select ‘BACK’ to save the
IP address and exit the menu.
To exit without saving any changes to the IP address allow the menu to
timeout (about 30 seconds).
Selecting the right arrow on the first system menu page will display the
second system menu page.
Figure 5-24: System Menu 2
LOCKING FRONT-PANEL ENABLE BUTTONS
(“LOCK”)
When LOCK is selected a menu appears that allows the user to lock
the front-panel enable buttons for party-line channel A, party-line
channel B, and the wired program source.
Figure 5-25: Lock Enable Menu
Selecting ON for the lock maintains whatever state the buttons are in
when they are locked. That state is maintained even when the base
station is turned off and re-started. The buttons can be locked either in
the enabled or disabled position, in any desired combination.
Selecting OFF allows the buttons to be toggled on and off with a single
push.
SYSTEM MENU
RMK BACK LOCK BATT
Lock on Enable buttons is currently OFF
BACK OFF NO