Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 28 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
2 - 2
To Connect to the CellCom Base Station to an Antenna
1. Connect a CAT-5 cable from transceiver port 1 on the CellCom base
station’s rear panel to a CellCom antenna. See Figure 2-1 for an
illustration (shielded CAT-5 is recommended).
2. Power up the base station.
3. Power up the beltpacks.
If the beltpacks do not connect to the base station within 30
seconds, check that they are registered to the base station. If they
are not, refer to the chapter “
CellCom Toolkit ” for instructions on
registering the beltpacks to the base station.
Figure 2-1: Connect the CellCom Base Station to the Wired Devices
4. To get the CellCom 10 into a “clean” state for the example below,
from the base station’s front-panel display, scroll to and select
PORTS, then 4WIR1, then CALLS, then NONE. (NONE is the last
element in the list.) Then also select PORTS, then PLCHA, then
CALLS, then NONE (See Figure 2-2).
POWER
PL CH-A PL CH-B PRGM IN SA OUT
SA RLY
4-WIRE / ECLIPSE PORTS
1 2 3 4
BASE
LOOP
LAN
PC PROGRAM
TRANSCEIVER
1 2
90-260V, 50/60Hz
80 Watts
2
3 4
CellCo m 10 Base Statio n Rear Pa n el
Co nn ect XLR cable to
party-li n e beltpack
Co nn ect CAT-5 cable
to 4-wire a u dio so u rce
Co nn ect CAT-5 cable to
CellCo m 10 a n te nn a
Cha nn el A
Eclipse Matrix
CellCo m 10 A n te nn a
Party-Li n e Beltpack
Always power up external
party-line equipment,
CellCom splitters, and
CellCom active antennas
before powering the CellCom
10 base station.