Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 34 / 168

Vitec Group Communications
CellCom-10 Instruction Manual
2 - 8
front-panel display flashes to indicate that the changes are being
saved and applied.
2. Ater a few seconds talk from the wired beltpack’s microphone.
• Audio from the wired beltpack should be audible on the two
wireless belpacks, and on the 4-wire audio device.
On the wireless beltpacks. the green (listen) light should be
flashing, indicating an incoming call to group #1 from a member of
group #1.
• Audio from the 4-wire audio device will be audible from the wired
beltpack’s headset.
3. If the base unit is powered down and then up again, the talk paths
from the wired beltpack (on party-line channel A) are re-established
to the 4-wire device and to the two wireless beltpacks.
4. It is possible to remove the talk paths from the wired beltpack’s party
line to the other devices by selecting PORTS, then PLCHA, then
CALLS, then NONE. This may also be done by disabling the party
line from the front panel of the CellCom base station by using the
CH A and CH B enable buttons provided that the party line is
powered from the base station as this will remove the power rather
than the audio. It will not remove the talk paths if the party line is
externally powered.