Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 47 / 168

Vitec Group Communications
CellCom-10 Instruction Manual 4 - 9
all people who have activated a talk/listen to that port will be allowed to
be able to hear each other, as well as hearing the person talking to
them from the CellCom 10 wireless beltpack, also check “Party-Line
Enable” for that 4-Wire connection in the configuration software.
Within the CellCom-10 Base Station configuration software, the user
can adjust the input and output level for that port. Alternately, the input
and output levels can be adjusted on the CellCom 10 base for the
particular 4-wire port, using the front-panel display. Repeat the
procedure for each CellCom 10 4-wire port that is connected with the
Matrix Plus system. Note that CellCom 10 does not currently generate
a call signal to the Matrix port.
CONNECTING TO CLEAR-COM ECLIPSE DIGITAL
MATRIX
The procedure to connect between a CellCom 10 4-wire port and the
Eclipse digital matrix is similar to that of Matrix Plus 3. An identical
connection is made with 4-pair CAT-5 cable between an Eclipse port
and the CellCom 10 port.
Within the Eclipse Configuration System software (ECS), set the port
to “Direct.” This will allow intercom panels in the Eclipse system to
converse with the CellCom 10 base and beltpacks. Because there is
not a “Party-Line Enable” within Eclipse, if several users of intercom
panels connected with Eclipse need to hear each other as well as the
wireless CellCom 10 beltpack, another procedure will need to be
added. Within the configuration software, the user would create a new
party-line label, with members including the desired intercom panels
and the particular CellCom 10 4-wire port. That label would then be
assigned to a key on each of the intercom panels, allowing connection
with the CellCom 10 4-wire port and the other members of the new
party-line.
Within the CellCom-10 Base Station configuration software, the user
can adjust the input and output level for that port. Alternately, the input
and output levels can be adjusted on the CellCom 10 base for the
particular 4-wire port, using the front-panel display. Repeat the
procedure for each CellCom 10 4-wire port that is connected with the
Eclipse system.
CONNECTING WITH OTHER DIGITAL MATRIX INTER-
COM SYSTEMS
Because CellCom 10 features standard 4-wire ports, with an input pair
and an output pair, virtually any 4-wire signal can be connected with it.
Make sure to properly match the input and output pairs between the
digital matrix port and the CellCom 10 4-wire port (see diagram below).
The pinouts for the first two 4-wire ports contain both audio and data
connections, though the data connections are not currently used.
Those pinouts are shown in the following table.