Clear-Com CELLCOM 10, Инструкция по эксплуатации

Страница: 49 / 168

Vitec Group Communications
CellCom-10 Instruction Manual 4 - 1 1
more CEL-BP wireless beltpacks, or to be added to a group with other
communications and assigned to beltpacks. Using the two separate
rotary encoder volume controls on the beltpack, the user can monitor
the program on one control while talking and listening on an intercom
channel with the other.
The balanced female 3-pin XLR connector accepts a standard audio
signal from a mixing console or similar, with Pin 1 ground, Pin 2 audio
hot (+), and Pin 3 audio cold (-).This connector is transformer-isolated.
To make the program input signal available to the system, the
front-panel PRGM enable button must be pushed. The red LED above
it will light, indicating that it is now available. This front-panel switch
may be “locked” to prevent accidental disengagement, using the front
panel display.
Using the front-panel display and rotary encoder, the user may select
PORTS and give the connector a five-character alphanumeric label.
The user may assign that program input by itself to a beltpack using
the BELTPACKS menu, or use the GROUPS menu to assign the
program input to any group.
CONNECTING TO THE STAGE ANNOUNCE
OUTPUT
The stage announce feature allows a CEL-BP wireless beltpack user
to route their voice to an external paging system or other audio
destination by pressing one of the rotary encoders to which the SA
OUT connector is assigned. The adjacent SA RELAY is simultaneously
triggered. One beltpack user at a time may use this feature, though the
capability may be assigned to any or all of the wireless beltpacks, as
desired.
Connect a microphone cable to the male 3-pin XLR connector on the
rear of the CellCom 10 base station, and connect the other end to the
external audio system. When the output is activated, the beltpack
user’s voice will be sent at line level to the audio system. The audio
output ceases when the beltpack user stops pressing the rotary
encoder; it is good practice to make sure that any rotary encoder to
which the SA OUT is assigned is set to momentary/non-latching mode.
PIN FUNCTION
1 Normally Closed
2 Normally Open
3 N/C (no connec-
tion)
4 N/C