CLEAN BURN CB-1400, Руководство оператора

Страница: 26 / 108

Operator's Manual: Model CB-1400
3-6
Installing the Connector Block, Oil Line Tubing, and Air Line Tubing
Installing the Connector Block
1. Refer to Figure 3F.
2. Install the mounting bracket on the furnace cabinet
using the two (2) bolts supplied.
3. Install the connector block on the mounting bracket
using the two (2) carriage bolts supplied.
4. Remove and discard the red caps and plugs from the
fittings and ports on the connector block. DO NOT
allow any dirt/debris to enter these components
during furnace assembly.
ATTENTION: The connector block includes an accumulator.
The accumulator functions like a shock absorber on the oil line
to prevent pressure buildup and protect vital burner
components. It is important that the connector block is
installed as shown so that the accumulator is in a vertical
position to prevent sediment from settling in the accumulator.
Never operate your furnace without the connector block and
accumulator properly installed on the furnace, or damage
may occur to vital burner components.
ATTENTION: DO NOT use teflon tape on any fittings.
Teflon tape residues will plug vital burner components.
Figure 3F - Installation of
Connector Block
Installing the Oil Line Tubing
NOTE: DO NOT disassemble the compression fitting from the swivel fitting. To prevent leaks, the NPT
threads of the compression fitting have been sealed with hydraulic sealant during assembly of the fittings at the
factory.
1.
Remove and discard the red caps from the oil line tubing.
2. Loosely install the oil line tubing into the oil line fitting on the burner.
3. Use a wrench to slightly rotate the oil line fitting on the burner counterclockwise so the tubing lines up
with the swivel assembly. Slightly bend the tubing as shown in Figure 3G, if required, to "line up" the oil
line.
4. If necessary, use a tubing cutter to cut the tubing to the proper length.
ATTENTION: Due to adjustment of the burner hinge bracket, the oil line tubing may need to
be cut to fit properly. DO NOT lift up on the burner when installing the oil line tubing to
compensate for oil line tubing that is too long. This will place the weight of the burner on the
swivel fitting and result in leaks at the swivel fitting seal.
I88824
AIR OIL
AIR OIL
SWIVEL ASSEMBLY
MOUNTING BRACKET
CONNECTOR BLOCK
DETAIL OF MOUNTING BRACKET AND
CONNECTOR BLOCK
CONNECTOR BLOCK
MOUNTING BRACKET
DETAIL OF OIL LINE AND AIR LINE
INSTALLED