ENGINEERS MANUAL
CST MACHINES AND DRYER UNIT
Drawn up: 05/10/2018
Document number : 30008893
Page 12 of 48
Revision: C
Water Inlet and Waste out let:
Water connection:
The appliance comes with a water supply hose requiring
a G¾” (¾” BSP) male threaded connection at the mains
water supply, upon installation and commissioning all
water joints must be checked for leaks.
Old existing, defective or damaged water supply hoses
are
NOT
to be used when installing the appliance.
Commercial appliance wash results will be affected by
external conditions such as incoming water
temperature, pressure, harness and choice of
chemicals.
For the longevity of any water related devices and to
ensure you get consistently good results it is essential your machine is either fed from a soft water
supply , or your
Classeq
appliance is connected to an appropriate water softener.
Note:
Water supply can be either side of the machine
.
IMPORTANT:
All supplier warranties are void if lime scale is present within an appliance
If the above requirements are not adhered to, the performance of the appliance will be impaired
CST 100 / 130
Temperature range
5-55°C
Pressure
0~2 bar Booster pump required
2~4 bar No modification
4~6 bar Flow restrictor required
6 bar +
Pressure reducing valve
required
Flow rate
4.7 Lts / min
Water connection
G ¾” (¾” BSP)
Inlet valve
Waste outlet / Drain hose
