Clarke Contractor CON15, Инструкция по эксплуатации и обслуживанию

Страница: 7 / 20

7
THE COMPRESSED AIR SUPPLY
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE THOROUGHLY FAMILIAR WITH SAFETY PROCEDURES RELATING TO
THE USE OF COMPRESSORS AND COMPRESSED AIR SUPPLIES.
A filtered, lubricated and regulated air supply will be required as shown in the
layout below.
Ensure the pressure available is within the range of 70-100 psi. Higher pressure
or contaminated air will shorten the tool’s life because of increased wear,
and could be a safety hazard. Higher pressure will also increase the noise
level.
The air inlet used for connecting the air supply has a standard ¼” BSP thread.
For best performance, a quick-fit connector can be used at each end of the
line.
Line pressure, or hose internal diameter should be increased to compensate
for unusually long air hoses (over 10m). Minimum hose diameter should be
6mm (¼”) ID, and fittings should have the same internal dimensions.
Check the quality of the compressed air supply before starting work. Water in
the air line will cause damage to the tool, and a dirty filter will reduce the
available air pressure.
Ensure there are no leaks in any of the connections.