Clarke Contractor CON15, Инструкция по эксплуатации и обслуживанию

Страница: 9 / 20

9
5. Offer the end of the strip of
nails into the gun, taking
care that the nail heads lay
flat in the groove (5) closest
to the machine body and
that the first nail in the strip is
resting in the drive pawl (6).
6. Close the magazine cover
and close the latch.
• This will not be possible if the
nails are not positioned
correctly. The machine is
now ready to use.
6 5
OPERATION
1. Connect the nailer to the air
supply. With the air supply
turned OFF, connect the air
line to the ¼” BSP connector.
(A Whip Hose with quick-fit
coupling is available from
your Clarke dealer).
2. Turn ON the air supply.
• Check for air leaks. If any are
apparent, rectify before
proceeding.
3. Ensure the operating pressure
is set to between 70-100psi .
This may be adjusted,
dependant upon the density of the workpiece. The harder the target
material, the higher the air pressure required. e.g. When nailing into
softwoods, a pressure of only 70psi may be all that is required. Quick release Airline Connection
NEVER OPERATE THE TOOL UNLESS THE SAFETY YOKE IS IN CONTACT
WITH THE WORKPIECE, OR WITHOUT ANY NAILS OR DAMAGE TO THE
TOOL COULD RESULT.