Clarke Contractor CON15, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 20

12
Grit or gum deposits in the tool may also reduce efficiency. This condition can
be corrected by cleaning the air strainer and flushing out the tool with gum
solvent oil, or failing this, the tool should be dismantled, thoroughly cleaned,
dried and reassembled. This is a task for your Clarke dealer.
If the tool runs erratically or becomes inefficient, and the air supply is sound, it
will be necessary to dismantle the piston assembly and replace worn or
damaged parts, which is best carried out by your Clarke dealer.
STORAGE
If the Coil Nailer is to be stored, or is idle for longer than 24 hours, run a few
drops of Clarke airline oil into the air inlet before storing.
Ensure the protective cap is replaced on the airline connector, once the
airline is disconnected.
ACCESSORIES & CONSUMABLES
A wide range of airline accessories is available, including Filter/Regulators.
Lubricators, High Pressure Hoses from 5 to 100 metres, Whip Hoses etc.
Contact your Clarke dealer for further information, or Clarke International
Sales Department on 01992 565333.
Wire-collated nails are available for the CON15 in three sizes:
Part No Nail Size
1800462 2.3 x 44mm Nails (300pcs)
1800464 2.5 x 50mm Nails (300pcs)
1800466 2.9 x 70mm Nails (250pcs)
Clarke airline oil (1 litre) is available from your Clarke dealer; Part No 3050825
IMPORTANT: The use of parts other than genuine Clarke replacement parts
may result in safety hazards, decreased tool performance and will invalidate
your warranty.