Clarke 7330367, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 28

9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
BEFORE USE
IMPORTANT: The engine is supplied without any oil in it and must be filled to
the correct level before use, see below.
CHECKING THE PUMP OIL LEVEL
1. Look at the sight glass on the
pump to check the oil level inside.
• The oil should be half way up
the sight glass.
2. Top up if required. See “Changing
the Pump Oil” on page 16.
• We recommend the use of
10W-SAE30 oil in this pump.
CHECKING THE ENGINE OIL LEVEL
1. Turn the oil filler cap/dipstick anti-
clockwise and remove it from the
oil filler tube.
2. Wipe the oil filler cap/dipstick with
a clean cloth.
3. Insert the oil filler cap/dipstick
back into the oil filler tube and
then remove it again. DO NOT
screw it in when doing this.
4. If the oil is low, fill the oil reservoir to
the edge of the oil filler hole.
• We recommend the use of
10W-SAE30 oil in the engine.
5. Replace the oil filler cap.
WARNING: TO CARRY OUT THIS CHECK, PLACE THE POWER WASHER ON
LEVEL GROUND WITH THE ENGINE SWITCHED OFF.
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS WHEN CHECKING
THE OIL LEVELS.
CAUTION: RUNNING THE
ENGINE WITH INSUFFICIENT OIL
WILL CAUSE ENGINE DAMAGE.