21
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
TROUBLESHOOTING
If the following does not solve your problem, please contact the CLARKE
service department.
PROBLEM
CAUSE
SOLUTION
Engine will not
start (see
engine manual
for further
engine
troubleshooting
No fuel
Add fuel. See page 10.
Low oil
Add oil. See page 16.
Pressure builds up
after two pulls on the
recoil starter or after
initial use
Squeeze the gun trigger to relieve
the pressure
Spark plug wire not
attached correctly
Attach the spark plug wire
Engine switch is in the
OFF position
Set the engine switch to the ON
position
Choke lever is set to
the choke position
with the engine warm
Set the choke lever to the NO CHOKE
position
Fuel valve closed
Open the fuel valve
Lack of
pressure (initial
use)
Water supply is not
adequate
Make sure your water supply can
deliver 5 gallons per minute at 20psi
Leak in the high
pressure hose fitting
Tighten the fitting, use sealant tape if
required
Nozzle is obstructed
Clear the nozzle
Water filter screen is
clogged
Remove and clean the filter
Defective E-Z start
valve
Have it replaced by your dealer
Air in the supply hose
Turn off the engine
Turn off the water supply,
Disconnect the water supply from
the pump inlet and turn on the water
to expel the air from the hose.
When all the air has been removed,
turn off the water supply and
reconnect the hose.
Turn on the water supply and pull the
trigger to expel any air in the gun/
wand
Содержание 7330367
Страница 28: ......