Clarke 6500690, Инструкция по эксплуатации и обслуживанию

Страница: 9 / 36

9
FEATURES
• The machine may be used in either the Mitre Saw mode, or Table Saw mode, as shown below.
• The table saw is used for rip cutting, cross cutting, including cross cut mitres, and bevel ripping.
See Specifications on page 4 for limitations of use.
• The mitre saw is used for cross cutting, mitre and bevel cross cutting or a combination of the two. See
Specifications on page 4 for limitations of use.
• Sawdust extraction devices are provided to maximise cleanliness and to avoid producing a dusty
environment.
• A switch panel incorporates the ON and OFF switches and features No Volt Relay device so that if
power is interrupted the machine will switch itself OFF and will not automatically start when power is
restored.
Fig.1
DEPTHS OF CUT
Please note that depths of cut are determined by the distance from the table to the underside of the
blade guard, with the saw blade at its highest level as indicated below.
It is important the riving knife is properly adjusted in order to achieve these measurements. Please refer to
the notes on page 28