Clarke 6500690, Инструкция по эксплуатации и обслуживанию

Страница: 7 / 36

7
MAXIMUM BLADE EXTENSION: Have the blade extended to approximately 2-4mm above the top of the
workpiece. Additional blade exposure could be potentially dangerous.
DO NOT REACH OVER : Do not reach over, or behind the blade for any reason.
SMALL PIECES AND TRAPPED PIECES: Do not pick up small pieces of cut-off material from the table. Remove
them by pushing them off the table with the push stick. They could be thrown back at you by the rear of
the blade. Do not remove small pieces of cut-off material that may become trapped inside the blade
guard while the saw is running. This could endanger your hands, or cause a
kickback . Turn the saw OFF
and when the blade has stopped turning, lift the guard and remove the piece of debris.
REBATING, SLOTTING AND GROOVING: Rebating, slotting and grooving should not be undertaken on the
saw..it is not designed for non-through cutting operations.
ADDITIONAL SAFETY RULES FOR TABLE SAWS
✔
ALWAYS use saw Blade Guard and Riving Knife for every operation.
✔
ALWAYS hold the work firmly against the mitre gauge or fence.
✔
ALWAYS use a pushstick when required. Always use a pushstick for ripping narrow stock.
Refer to ripping applications in instruction manual where pushstick is covered in detail.
✔
ALWAYS use in a well ventilated area. Remove sawdust frequently. Clean out sawdust from
the interior of the saw to prevent a potential fire hazard.
✔
ALWAYS move the rip fence out of the way when crosscutting.
✔
ALWAYS switch off and disconnect from supply before removing off cuts of wood from the
machine
✔
ALWAYS provide adequate support to the rear and sides of the saw table for wide or long
workpieces.
✔
ALWAYS keep the blade sharp, the Rip Fence parallel to the saw blade, and the Riving Knife
and Blade Guard in place. Do not release work before it is pushed all the way past the saw
blade.
✔
ALWAYS avoid awkward operations and hand positions where a sudden slip could cause
your hand to move into the blade.
✘
NEVER stand or have any part of your body in line with the path of the saw blade. Keep
your hands out of the line of the saw blade.
✘
NEVER reach behind or over the blade for any reason.
✘
NEVER use the fence as a cutoff gauge when crosscutting.
✘
NEVER attempt to free a stalled saw blade without first turning the saw OFF. Turn off power
switch immediately to prevent motor damage.
✘
NEVER use solvents to clean plastic parts. Solvents could possibly dissolve or otherwise
damage the material. Only a soft damp cloth should be used to clean plastic parts.
✘
NEVER force feed the work into the blade. A light pressure ONLY is required
✘
NEVER cut metals or materials which may make hazardous dust.
✘
NEVER perform any operation ‘freehand’ which means using your hands to support or guide
the work piece. Always use either the fence or the mitre gauge to position and guide the work.