17
1. Remove Blade Guard
•
With the saw in table saw mode, it is first of all necessary to remove the blade guard by
undoing and removing the pivot bolt. Replace the bolt with nut and flat washer in the
removed blade guard for safe keeping.
IMPORTANT! It is necessary to attach the dust
chute, which covers the saw blade, but in
order to do this, the riving knife must firstly be
‘parked’ The quickest method of
accomplishing this is as follows:
2. Rotate Table
•
With your right hand, grasp and pull out
the table locking lever fully, as shown in
Fig.12, then push down on the table.
•
Release the table locking lever and turn
the table through 180 degrees, pushing
down firmly so that it locks into place as
shown in Fig.13.
WARNING:
1. DO NOT put your hand or fingers
between the table and the side panels.
2. Take great care to avoid contact with the
saw blade, otherwise severe damage to
hands or fingers could occur.
Fig.12
3. Raise Head
•
Grasp the handle as shown in Fig. 14, and
push down fully, then turn the lock knob,
as shown in Fig14, fully
clockwise
i.e. half
a turn.
•
Release pressure on the handle and allow
the mitre saw head to rise to its full height,
as shown in Fig.15 - under full control.
Fig.13
Fig.14
Fig.15
B. Preparing The Mitre Saw
Содержание 6500690
Страница 31: ...31 PARTS DIAGRAMS...
Страница 32: ...32...
Страница 33: ...33...
Страница 36: ...36...
