Clarke 6500690, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 36

12
FAMILIARISATION AND PREPARATION FOR USE
Your Flipover saw is fully assembled at the factory, Once unpacked, very carefully, and with
assistance, either invert the unit so that it rests on the table top as shown in Fig.1, or rest it on its
rear edge. Note that the saw blade is fully retracted and therefore the table top will lay flat on
the floor. This is in ‘Transport Mode’, and when transporting, the saw blade should always be
fully retracted.
Unclip the leg restraint and raise the legs, as shown in Fig.1, ensuring the locking levers spring
into place. Check to ensure the legs are firmly locked, before carefully, and with assistance,
raising the unit on to its feet.
Adjust the foot, by turning it clockwise or anticlockwise, as required, so that the unit is completely
stable.
Fig.1
(from transport mode)
With the saw on its feet, note that the riving knife, shown in Fig.2, is ‘parked’ alongside the saw
blade guard. For Table Saw use, it is essential that the riving knife is properly located at the rear
of the saw blade, and this is accomplished as follows:
Fig.2
A. Preparing The Table Saw
• Undo the riving knife locking knob fully to allow the complete riving knife assembly to be
free of its housing.
NOTE: Undo the knob ONLY - do not interfere with the bolt or locknut
REAR