Clarke 6500690, Инструкция по эксплуатации и обслуживанию

Страница: 15 / 36

15
2. The Mitre Gauge
The Mitre Gauge should be used for all cross
cutting operations.
Attach the sliding bar to the underside of the
mitre gauge, securing with the large hand
knob, then, attach the mitre gauge to the mitre
gauge fence using the two knobs shown in
Fig.9.
Fig.9
The sliding bar of the mitre gauge engages
with the slot in the table - either left, as shown,
or right.
The mitre gauge may be set at any angle up
to 45 degrees (as shown), for cutting mitres.
Place, and hold the workpiece against the
gauge fence, as shown, and feed it into the
saw blade by gently pushing the mitre gauge
in its slot.
Fig.10
The pointer may be zeroed for accuracy, using
a square, as shown in Fig.11. Undo the large
hand knob, and tighten again when the sliding
bar is exactly at right angles to the fence.
Slacken off the pointer securing screw and
retighten with the pointer directly on the 90
degree mark.
Fig.11
The Table Saw and ancillary components are now fully assembled and ready for use, but do
not do so until you have read and fully understand the instructions given under ‘Operation’, on
page 18.