-9-
VIOLET: (+) Door trigger input.
Connect to the wire that shows +12V when the door is open.*
GREEN: (-) Door trigger input.
Connect to the wire that shows ground when the door is open.
*
BLUE: (-) Hood trigger input.
Connect to the hood pin switch. Be sure this wire shows ground when the switch
is opened. This input functions as a safety shutdown and must be connected.
ORANGE: (-) Armed output 500mA.
This wire provides a ground output when the unit is armed. This wire can be used
to activate an optional circuit interrupt or other device (i.e.: window module, etc).
GREEN/BLACK: (-) Factory disarm output 125mA.
This wire provides a ground output to disarm a factory security system when the
remote is used to unlock the doors or start the vehicle.
GREEN/WHITE: (-) Factory rearm output 125mA.
This wire provides a ground output to rearm a factory security system when the
remote is used to lock the doors or when the remote start shuts down.
BROWN: (+) Siren output 3A.
Connect to the siren's red wire. Connect the black wire of the siren to (-) chassis
ground. (It is recommended to ground the siren at the same point as the main unit.)
YELLOW/WHITE: (-) Auxiliary 1 output 500mA.
Connect to a relay for an optional feature such as a trunk release solenoid, window
module, headlight activation, etc. The Auxiliary 1 output can be programmed for
momentary, timed, or latched activation.
WHITE: (+/-) Parking light output (10A relay).
The output polarity of this circuit can be selected for either (+) positive or (-)
negative output via the internal jumper. Make sure to verify the polarity of the
parking light circuit before setting the jumper.
BROWN/WHITE: (-) Horn Honk Output 500mA.
Connect to a relay to pulse the horn when the security system is triggered. (See
Horn Honk Relay Diagrams for assistance.)
* Diode isolate the door trigger wires for vehicles with separate door trigger wires.
8.3 3-Pin Door Lock Harness:
(See Door Lock Diagrams for assistance.)
Green: (
-
) Lock
Red: Not Used
Blue: (
-
) Unlock
MS2107 install.qxd 8/25/2003 12:50 PM Page 9
Содержание UNGO MS2105
