Clarion UNGO MS2105, Руководство по установке

Страница: 11 / 32

-11-
Programming the primary remote transmitter to the second vehicle:
1. Turn the ignition ON, OFF, ON, OFF, and leave ON.
The siren will chirp once.
2. Press and hold the Valet/Override switch for 5 seconds.
The siren will chirp once.
3. Press Button 5 twice followed by the Lock button on the transmitter.
The siren will chirp once.
4. Press Button 5 twice followed by the Lock button on the transmitter again.
The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional transmitter.
6. Turn OFF the ignition when transmitter programming is complete.
The siren will chirp 3 times.
12. Programmable System Parameters
The Ungo MS2105/MS2107 has 2 independent programmable parameter tables.
One parameter table is for User's and the other is for Installer (see chapter 14).
These parameter tables can be modified using the Ungo-Net computer interface or
by using the Valet/Override button. The Ungo-Net interface allows for additional
custom features and settings not accessible through the Programming Table.
13. User Programmable Parameters
User Programming Table
1. Arming Mode Active Passive
2. Auto Rearm On Off
3. Arming Chirps Normal Silent
4. Ignition Controlled Door Locking On Off
5. Ignition Controlled Door Unlocking All Doors Driver’s Door Off
6. Override Code Programming Code Set
7. Remote Start in Valet Mode Enabled Disabled
8. Automatic Starting Every 2 Hours Every Hour
9. Engine Run Time 15 minutes 25 minutes
Feature Button 1 (default) Button 2 Button 3
MS2107 install.qxd 8/25/2003 12:50 PM Page 11