City Theatrical SHoW DMX Neo 5701, Инструкция по установке и эксплуатации

Страница: 54 / 71

54
panel will automatically lock and return to the main status screen. If any parameters were being
edited at the time of lockout, that parameter will return to its previous state.
The lockout feature can be enabled or disabled via the Misc. Menu (see below). By default the
button panel lockout is set to disabled.
Back Panel
Power Input Jack: This is the +12VDC power input for the 5701 Transceiver and mates directly
with the plug on the CTI # 5627 power supply, as well as the CTI # 5550 Battery Twofer.
Although provided with a CTI 12VDC power supply (such as the 5727 above), the 5701’s
internal power circuit will work with any +DC voltage power supply from 9 to 24VDC, allowing a
wide range of battery power options. This connector’s polarity is Ring- / Tip+.
Be sure the power
connection is polarized correctly before connecting an alternative supply.
DMX Termination Switch: The 5701 Transceiver DMX Port is provided with a conventional
manual termination switch. Switch the handle to ON for end-of-line DMX Termination.
Standard CTI # 5530 7” 5dBi Omni Directional Antenna: This antenna is removable and
position-able. The SHoW DMX Neo Transceivers and Receivers are certified with this antenna
and should be used with it or another approved antenna only to assure compliance.
5P XLR Male and Female Connectors: DMX Port. Connect your DMX512 source here using any
ESTA compliant DMX512 cable. These two connectors are wired in parallel. Port direction is
controlled by configuration options.
RJ45 Jacks: Ethernet lighting control input. This input is for connection to a lighting control
Ethernet network or connection to a PC for use with the Jese GetSet RDM Controller.
USB A Port: This port is used for firmware installation and upgrades only. Firmware updates are
posted on the City Theatrical, Inc. website
To Install a Firmware Update:
Download the new firmware file from the CTI Website
Place file in root directory of a FAT (16 or 32) formatted USB memory stick
Plug stick into USB jack
Browse to “Misc->Firmware->Update”
Wait for unit to reboot with new firmware
Once complete, remove USB stick
The SHoW DMX Neo Transceiver Menu Structure
The SHoW DMX Neo System has many user configurable features to enhance performance
and minimize impact on other RF systems. The SHoW ID allows most of the critical RF settings
to be set in the Transceiver, and then easily transferred to the Receiver by simply setting the
SHoW ID in the Receiver (see
About Show ID , below).