57
Hop Pattern:
For Classic or Neo Modes, select one of 16 hopping patterns. For Neo Adaptive
Mode, select one of four Universes (A-D). Each hopping pattern is unique and will configure the
broadcast so that only receivers with the same hopping pattern will sync up with that Transmitter
and receive the DMX broadcast.
Power:
Select the desired transmit power setting. The power settings are 1mW, 14mW, 28mW,
or 72mW ETSI.
Bandwidth:
Select one of four Bandwidth options: Full, Wi-Fi 1-6, Wi-Fi 4-9, or Wi-Fi 7-12.
# of Channels (limited burst):
Select the full burst of 512 DMX channels (slots), or a shorter
limited burst.
Neo Mode:
Limited burst options begin with 51 DMX channels and increase in increments of
52, so the options are 51, 103, 155, etc. to 467.
Slot Start Addr:
If a Limited burst is selected, select the first transmitted DMX Slot, e.g.
with a setting of 51 slots and a Start Address of 1, the broadcast slots would be 1-51.
Classic Mode:
Limited burst options begin with 30 DMX channels and increase in increments of
32, so the options are 30, 62, 94, 126, etc. to 478 .
Slot Start Addr:
If a Limited burst is selected, select the first transmitted DMX Slot, e.g.
with a setting of 30 slots and a Start Address of 31, the broadcast slots would be 31-60.
DMX512 / Art-Net / sACN Control Input
The SHoW DMX Neo Transceiver will accept DMX512, Art-Net, or sACN control input. All inputs
are live and will be combined in a Highest level Takes Precedence (HTP) arrangement. If a
network protocol is used, you must configure the network settings for your Art-Net/sACN
network in the Network Settings menu.
Input Settings
The input settings menu allows you to select the input format for the system and change any
additional input specific settings. The Neo Transceiver currently supports DMX, Art-Net, and
sACN. The Art-Net implementation incorporates source addressing as defined in the PRG S400
distribution system.
DMX Port Direction:
Set the DMX Port as an Input or an Output. When set as an output
in Transmit mode, a DMX Universe from incoming network protocols can be assigned to
this port separately from the Universe selected for wireless broadcast.
sACN Settings:
•
Select the desired wireless universe number
•
Select the desired wired universe number (only active if the DMX Port is set as
an Input)
Содержание SHoW DMX Neo 5701
Страница 9: ...9 5792 SHoW DMX Neo Radio Module CE Declaration of Conformity ...
Страница 21: ...21 Antennas ...
Страница 22: ...22 Antenna Accessories ...
Страница 24: ...24 Antenna Connectors These connectors are referred to in the table above ...
