City Theatrical SHoW DMX Neo 5701, Инструкция по установке и эксплуатации

Страница: 70 / 71

70
SHoW ID
Like the original SHoW DMX Classic system, the SHoW DMX Neo system uses SHoW IDs as a
quick way to set RF configuration options. Each SHoW ID represents a combination of one of
16 hopping patterns and one of four bandwidth settings.
The Transmitter and Receiver SHoW IDs must match for the units to communicate.
The SHoW DMX Vero Net Transceiver is preset at the factory with SHoW ID 201 for Adaptive
Spread Spectrum Frequency Hopping and Neo Low Latency broadcast mode.
SHoW ID may be set manually using the SHoW ID ROTARYs or using RDM. Whichever
method is used last takes precedence.
To set the SHoW ID manually, simply set the SHoW ID ROTARY Switches to the desired SHoW
ID.
In order to use RDM, you will also need an RDM controller or a lighting control console with a
built-in RDM controller.
You can set SHoW ID either with the ROTARY switches as described, or via RDM. All other RF
settings must be set via RDM.
RDM Operation
Remember that when RDM is enabled, the system uses ~ 25% of its available DMX bandwidth
for RDM so DMX fidelity and refresh rate are reduced. For best DMX fidelity, disable RDM traffic
from the Receivers back to the Transmitting unit when you are not using RDM.
You can use RDM to change SHoW IDs in connected devices. Remember that once you have
changed the SHoW ID in a connected Receiver, you will lose communication with that Receiver
until you change your Transmitter to the matching SHoW ID.
The SHoW DMX Vero Net Transceiver is fully enabled as an RDM proxy system, so you can
use RDM to manage your SHoW DMX Vero Net Transceiver system and any connected RDM
responders that are downstream of the system.
The SHoW DMX Vero Net Transceiver supports the following RDM PIDs:
Get
Allowed Set
Allowed Reduce
d RDM
RDM Parameter PID Comment
X
DISC_UNIQUE_BRANCH 0x0001
X
DISC_MUTE 0x0002
X
DISC_UN_MUTE 0x0003
X X PROXIED_DEVICES 0x0010
X X PROXIED_DEVICE_COUNT 0x0011
X X QUEUED_MESSAGE 0x0020
X X SUPPORTED_PARAMETERS 0x0050