9. TIGHTEN ALL HARDWARE.
Tighten the side hex screws, the bottom retaining bolt, iris slot cover
screws and both the beam focus knob and the barrel rotation knob. This step is of the utmost
importance.
IF THE HARDWARE IS NOT TIGHT, YOU RISK INACCURACY, NOISE, AND THE
POSSIBILITY OF THE LIGHTING FIXTURE DETACHING FROM THE AUTOYOKE.
(Example 6)
10.
Plug the lighting fixture cable with the male stage pin connector into the female stage pin connector
on the cradle connector box.
3-3
INSTALLING THE LIGHTING FIXTURE POWER CONNECTOR ON THE AUTOYOKE
When AutoYoke is ordered without a lighting fixture power connector (standard factory configuration is
three pin stage connector), use the following instructions to install the connector:
1.
Strip cable jacket back 1 - 1/4”.
2.
Strip 1/2” of insulation from end of each connector.
3.
Attach conductors to pins per connector manufacturers instructions. The body of the connector
should be marked with a “N”, “G”, and “H”. This corresponds to:
N:
Neutral
(white wire)
G:
Ground
(green wire)
H:
Hot
(black wire)
Wire pins in the following order: “N” first, “G” second, “H” third.
-9-
barrel rotation knob
iris slot cover screws
lighting fixture mounting screws
retainer bolt
beam focus knob
EXAMPLE 6
