4-2
Addr
Addr
-
ADDRESS
The AutoYoke requires 7 channels (16-bit) or 5 channels (8-bit) per fixture to operate. The scroller
requires an address other than those addresses occupied by the AutoYoke. When using a Wybron CXI
scroller, the scroller must be addressed at
001
001
, and it will occupy 3 control channels - the 8th, 9th, and
10th in the sequence when operating in 16-bit and the 6th, 7th, and 8th when operating in 8-bit. When
using a Coloram II scroller, the address at the head (rotary switch) is inconsequential, but the scroller will
always occupy the 8th channel in the sequence (in 16-bit) and the 6th channel in the sequence (in 8-bit).
All other specified scrollers can be set at a user selected DMX address as long as it is not occupied by an
AutoYoke attribute. It is only necessary to select the first DMX address for the AutoYoke.
*NOTE: WHEN USING COLORAM II SCROLLERS, SET THE DIP SWITCHES AS FOLLOWS:
Switch 1 - OFF (Motor Speed - Normal)
Switch 2 - ON (Operation - 24-Chan)
Switch 3 - OFF (Chan Range - 1~12)
Switch 4 - OFF (Fan Speed - Remote Xtrol)
DMX CHANNEL ASSIGNMENTS
16-bit
8-bit
1 - Pan Course
1 - Pan
2 - Pan Fine
2 - Tilt
3 - Tilt Course
3 - Iris
(occupied if not used)
4 - Tilt Fine
4 - Focus (occupied if not used)
5 - Iris
(occupied if not used)
5 - Control Channel
6 - Focus
(occupied if not used)
**Address scroller independently
7 - Control Channel
**Address scroller independently
1.
Turn on the AutoYoke. Pan, Tilt, Iris and Focus will AutoCalibrate as the word
Go
Go
travels across the
LED display (This will only occur if the AutoYoke is still configured with Factory Defaults. See Section
4-9 for Factory Default settings). If the AutoYoke is receiving DMX, it will travel to the DMX values
once it has calibrated. If the AutoYoke is not receiving DMX, it will move to a 50/50 position on
the Pan and Tilt axes upon the completion of calibration. The 50/50 position is at the halfway
point of the attributes' travel range. See Section 5-2 for further information about the 50/50 position
.
***
Note: If the AutoYoke is not receiving DMX, a series of dashes will continuously travel across the
LED display
***Note: The scroller is not part of the AutoCalibrate or Calibrate routine, but will autodetect and
self - test at Power Up.
2.
Press
Menu
:
Addr
Addr
(Address)
Addr
Addr
will appear on the display.
-17-