4.
Tighten the barrel rotation knob into the hole from which you previously removed the retainer bolt. The
barrel rotation knob should now be on the same side as the iris slot.
(Example 2)
5.
With its iris slot on top, rest the lens tube of the lighting fixture inside the cradle of the AutoYoke. The
lighting fixture’s cable with the stage pin connector should lie between the cradle and the lighting fixture
(NOT directly beneath the lighting fixture), on the same side of the cradle as the female stage pin
connector on the connector box.
6.
Using a flat head screwdriver for leverage between the
lighting fixture and the AutoYoke cradle,
GENTLY
maneuver
the lighting fixture into the cradle. When the lighting fixture
is in the correct position, the holes on the sides of the
lighting fixture from which you removed the hex bolts will
line up with the matching holes on the cradle.
(Example 3)
***Note: If the lighting fixture will be permanently installed
in the AutoYoke, City Theatrical Inc. suggests
cutting the lighting fixture cable to 22” to eliminate
interference with the movement of the fixture in the yoke.
***Note: The lighting fixture must have a three pin stage
connector to plug directly into the AutoYoke.
New position of
barrel rotation knob
Old position of
barrel rotation knob
-7-
EXAMPLE 2
Slide lighting
fixture in from
rear of cradle.
screwdriver
These holes must
match up.
EXAMPLE 3