75
Printouts generated when Unit Toggling is done
between Application Unit (
Tot
), Unit1 and
Unit2 and Reference Weight is changed
Printouts generated when Unit Toggling is done
between Application Unit (
Tot
), Unit1 and
Unit2 and Reference Weight is changed
When GLP ON
When GLP OFF
-------------------------------
28-Jul-10
03:19PM
Citizen
Model
CX 220
Ser.no.
9223102
Ver.no.
r0.1.5.3
ID
1234567
-------------------------------
-------------------------------
28-Jul-10
03:23PM
Name:
................
-------------------------------
nRef
10 pcs
wRef
2.0000 g
N1 +
10 pcs
Tot +
10 pcs
N2 +
25 pcs
Tot +
35 pcs
N3 +
10 pcs
Tot + 45 pcs
N 3
Tot +
45 pcs
nRef
10 pcs
wRef
2.0000 g
N1 +
10 pcs
Tot +
10 pcs
N2 +
25 pcs
Tot +
35 pcs
N3 +
10 pcs
Tot + 45 pcs
N 3
Tot +
45 pcs
If the balance is connected externally to PC or Printer through RS 232 C then, whenever user
enter into the reference menu of Totalization function & make changes in the reference setting,
automatically printout is generated on the Peripheral attached.
In the printout, reference number “nRef” and reference weight “wRef” is printed. After this user
can Press Print Key to Print the reading on the display.
Also user can Toggle to other unit through Toggle key & Press Print Key to get the print out of
those corresponding units.
6.7.2 Auto Totalization
Auto totalization presupposes that you have selected the 'F tot AUTO' in the user menu.
totalization
totalization
totalization
totalization
Procedure
ð
Place the empty container on the pan.
ð
Press the <TARE> key briefly to tare the balance.
ð
Press the <TOGGLE> key briefly until “
tot”
and AUTO is displayed on the display.
Your balance now needs the weight of a reference number.
ð
Press and hold the <TOGGLE> key until you are prompted to load the reference pieces.
ð
Your balance suggests the last selected reference number.
You can accept this suggestion or select one of the other reference numbers available
(5, 10, 20, 50, 100 pieces) by briefly pressing the <TOGGLE> key.
ð
Now place the selected number of reference pieces on the pan.
ð
When you have placed exactly the same number of pieces on the weighing pan as
selected reference pieces press TARE key.
As soon as the weighing result is stable, the calculated average piece weight is
accepted as the reference.
ð
Add weight on the pan. Weight can be added to summation when “ ” is
displayed on the display i.e. when number of pieces is greater than 2.
ð
When the weight is stable the number of pieces is stored in the totalization procedure
st
and the balance displays “
n-1
” indicating that 1 weight is stored. The weight is tarred
automatically and simultaneously print command is given. Thus there is no need to
press any to start the auto totalization procedure.
Note :
You can use the <TOGGLE> key at any time to switch the display between
totalization, weighing unit 1 and weighing unit 2. User can go to Standby mode by pressing
on/off key and go to Simple Weighing with unit 1 by CANCEL key and balance shows
Current weights.
Auto
proves to be beneficial when the balance is used in majority for
weighing and less for simple weighing thus reducing the time required for
as
compared to manual
Note :
1) User cannot enter into the external calibration or menu when GLP is ON
has not been printed.
2) To print footer user will have to Press <CANCEL> key.
& footer
76
