Cissell FMCD, Руководство пользователя

Страница: 16 / 40

Page 16 Page 16
Page 16 Page 16 Page 16
CISSELL FORM FINISHER CISSELL FORM FINISHER
CISSELL FORM FINISHER CISSELL FORM FINISHER CISSELL FORM FINISHER
Lubrication of Bearing Areas and Installation of Metallic Steam Spreader
INSTRUCTIONS FOR LUBRICA INSTRUCTIONS FOR LUBRICA
INSTRUCTIONS FOR LUBRICA INSTRUCTIONS FOR LUBRICA
INSTRUCTIONS FOR LUBRICATING BEARING TING BEARING
TING BEARING TING BEARING
TING BEARING
SURFACES SURFACES
SURFACES SURFACES
SURFACES WITHIN FORM FINISHER WITHIN FORM FINISHER
WITHIN FORM FINISHER WITHIN FORM FINISHER
WITHIN FORM FINISHER
NOTE: Inspect bearing areas at least every 30 days. If an
accumulation is evident, bearing surfaces must be cleaned
and lubricated.
FIRST: Lift revolving form up and off of steam chamber.
SECOND: Sand off old lubricant, or foreign matter, from bearing
surfaces A and A1.
THIRD: Wipe dust and lint off of surfaces A, A1, B, B1, C and D.
FOURTH: Spread DOW CORNING “VALVE SEAL A” (Heat Stable
Silicon Lubricant) with a piece of cardboard over surface A,
and apply to bearing points C and D. With Finger, pack
inside of dome above ball bearing B1 with Valve Seal A.
T T
T T
TO REPLACE MET O REPLACE MET
O REPLACE MET O REPLACE MET
O REPLACE METALLIC ALLIC
ALLIC ALLIC
ALLIC
STEAM SPREADER STEAM SPREADER
STEAM SPREADER STEAM SPREADER
STEAM SPREADER
FIRST: Remove old metallic spreader if it
fails to diffuse steam properly.
SECOND: Fold new copper mesh “L” over,
three times, into approximately a
1 1/2” width band, 18” long.
THIRD: Wrap copper mesh tightly around
valve body.
FOURTH: Place perforated brass draw band
with ring “M” around copper
mesh. Feed end of band through
ring and pull band tight. Fold
band back over ring with a pair of
pliers to keep band tight.
INSTRUCTIONS FOR LUBRICA INSTRUCTIONS FOR LUBRICA
INSTRUCTIONS FOR LUBRICA INSTRUCTIONS FOR LUBRICA
INSTRUCTIONS FOR LUBRICATING BEARING TING BEARING
TING BEARING TING BEARING
TING BEARING
POINTS ON OUTSIDE OF BASE POINTS ON OUTSIDE OF BASE
POINTS ON OUTSIDE OF BASE POINTS ON OUTSIDE OF BASE POINTS ON OUTSIDE OF BASE
Wipe bearing surfaces clean and oil with a
lightweight oil, at least every 60 days.
NOTE:
Nylon bearings do not require lubrication.