Cissell FMCD, Руководство пользователя

Страница: 39 / 40

Page 39 Page 39
Page 39 Page 39 Page 39
CA CA
CA CA CAUSE
USE
USE USE USE
10C Bag size levers not properly
set
10D Bag improperly installed on
frame
10E Defective damper operating
linkage
11 Damper opening spring
defective
12A Steam timer setting too short
12B Valve not opening properly
13A Pressure setting too low
13B Defective damper operating
linkage.
13C V belt loose
13D Motor pulley loose
13E Blower pulley loose
13F Lint or inlet screens
14A Foreign object in blower
wheel
14B Blower wheel out of balance
14C Blower shaft bent
14D Worn blower shaft bearings
14E Worn motor brgs.
REMEDY REMEDY
REMEDY REMEDY REMEDY
Move the sizing levers until the
bag is properly sized.
Refer to bag installation
instructions and check to see that
bag strings ane untangled and
properly connected.
Inspect linkage and levers between
air solenoid and damper. Be sure
they are arranged and adjusted
according to instructions. Replace
any broken or stretched springs.
Repair or replace any defective
parts.
Inspect damper springs. Replace
any broken or stretched spring.
Increase timer setting with knob
on face of timer.
Inspect steam valve linkage to
steam solenoid and adjust
according to instructions. Repair
or replace any defective parts.
Tighten all lock nuts and set
screws.
Increase air pressure in the bag
with pressure control lever.
Inspect linkage and levers between
air solenoid and damper. Be sure
they are arranged and adjusted
according to instructions. Replace
any broken or stretched springs.
Repair or replace any defective
parts.
Check to see that the V belt is on
and properly aligned and adjusted
according to instructions.
Inspect V belt pulley on motor
shaft to see that it is properly
positioned and set screw well
tightened on shaft flat.
Inspect V belt pulley on blower
shaft to see that it is properly
positioned and set screw well
tightened on shaft flat.
Clean inlet screens every morning
at start of work day.
Inspect wheel and remove any
foreign objects and lint.
Inspect wheel for loose balance
weights, out of round or damage.
Replace wheel if necessary.
Inspect to see that blowers shaft is
straight. If not, replace it.
Check to see that shaft is tight but
free to turn in brgs. If brgs. have
very loose fit on shaft, replace
brgs.
Run motor with V belt removed
and check by feel to see that brgs.
are good. Replace motor if
necessary.
PROBLEM PROBLEM
PROBLEM PROBLEM PROBLEM
(10) Bag won’t inflate to garment
size (Con’t.)
(11) Bag won’t deflate
(12) Inadequate steam
(13) Inadequate air
(14) Excessive noise or vibration