Cissell FMCD, Руководство пользователя

Страница: 38 / 40

Page 38 Page 38
Page 38 Page 38 Page 38
CA CA
CA CA CAUSE
USE
USE USE USE
7E Loose wiring
7F Defective air solenoid
7G Defective air solenoid linkage
7H Damper plate stuck
7I Improper air operating lever
assembly
8 Stretched damper springs
9A Defective air timer
9B Defective air relay
9C Defective air solenoid
9D Broken or stretched damper
opening spring
10A Pressure setting too low
10B Pressure control defective
REMEDY REMEDY
REMEDY REMEDY REMEDY
Inspect machine wiring, especially
to steam timer contacts and air
relay. Replace any loose wires and
tighten any loose connections.
Inspect the air solenoid. Replace if
it is burned, armature does not
move freely, or if it will not operate
on a rated voltage.
Inspect linkage and levers between
air solenoid and damper. Be sure
they are arranged and adjusted
according to instructions. Replace
any broken or stretched springs.
Repair or replace any defective
parts. Tighten all set screws.
Check to see that damper plate
can freely open and close when air
is off. If not free the damper.
Repair or replace if necessary.
Adjust according to instructions.
Refer to parts dwgs. and assemble
levers on damper shaft properly.
Pins on these levers must be
properly arranged with respect to
adjoining levers. Repair or replace
any defective parts and adjust
according to instructions. Replace
all springs and tighten all set
screws.
Inspect damper springs. If
stretched or broken replace it. See
adjustment section.
Check timer operation. See that
timer motor will run and that
timer switches operate properly. If
not, replace timer.
Check to see that the air relay will
operate properly and the contacts
are free to move (not welded). If
not, replace the relay.
Inspect the air solenoid. Replace if
it is burned or armature does not
move freely.
Inspect damper operating springs.
Check parts dwgs. and replace
spring if required.
Increase pressure in the bag with
the pressure control lever.
Inspect damper control wire,
levers and pressure control lever.
Be sure that all parts are con-
nected and adjusted according to
instructions. Repair or replace
any defective parts.
PROBLEM PROBLEM
PROBLEM PROBLEM PROBLEM
(7) Auto air won’t come on
(Cont.)
(8) Relief damper “flaps”
(9) Auto air won’t stop
(10) Bag won’t inflate to garment
size