Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574, Руководство по установке оборудования

Страница: 65 / 112

5-7
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
OL-17738-01
Chapter 5 WAVE Inline Network Adapter
Inline Network Adapter Cabling Requirements
Step 2
Connect Fast Ethernet ports on both the LAN and the WAN sides of the WAVE
inline appliance by using the following cable types:
•
On the LAN side of the connection, use a straight-through cable between the
WAVE inline appliance and the network device.
•
On the WAN side of the connection, use the cable that is different from the
cable that you would use to connect the two network devices directly (as
determined in
Step 1 ).
For example, if you are connecting a router and a switch (two different
devices) through the WAVE inline appliance, use a straight-through cable on
the LAN side of the connection and use a crossover cable on the WAN side
of the connection. (If you were connecting the two different devices directly,
you would use a straight-through cable, so use the crossover cable instead.)
If you are connecting two switches (or two similar devices), use
straight-through cables on both the LAN and the WAN sides of the WAVE
inline appliance.
Figure 5-3 through Figure 5-5 show which cables to use for the WAVE LAN
and WAN connections between Fast Ethernet ports.
Router to WAVE and
WAVE to Router
Straight-through
Straight-through
WAVE to WAVE Crossover
Table 5-3 Cable Requirements for WAVE Connections Using Fast Ethernet
(continued)
Connection Required Cable