Cisco WAVE-574-K9 - Wide Area Virtualization Engine 574, Руководство по установке оборудования

Страница: 55 / 112

4-7
Cisco Wide Area Virtualization Engine 574 Hardware Installation Guide
OL-17738-01
Chapter 4 Installing Hardware Options for the WAVE-574
Replacing a Hard Disk Drive
Figure 4-4 Removing a Hard Disk Drive
Step 5
Pull the drive assembly from the bay.
Step 6 Wait 1 minute and then insert the new drive into the same slot by aligning the
replacement drive assembly with guide rails in the bay and sliding the drive
assembly into the bay until it stops. Make sure that the drive is properly seated in
the bay.
Step 7
Close the drive handle.
Step 8
Reboot the WAVE appliance.
Step 9
Check the hard disk drive status LED after the system has booted to verify that the
hard disk drive is operating correctly. If the amber hard disk drive status LED for
a drive is lit continuously, that drive is faulty and must be replaced. If the green
hard disk drive activity LED is flashing, the drive is being accessed.
Step 10
Wait 1 minute and then verify that the replaced disk drive is in the Rebuilding state
by using the
show disks details command in EXEC mode.
Note
The system automatically starts the rebuild operation when it detects the
removal and reinsertion of a drive that is part of the logical RAID drive.
Step 11
Wait until the rebuild operation is complete. A disk rebuild operation may take
several hours. You can check if the rebuild operation is complete by using the
show disk details command in EXEC mode. The physical drive state will be
Online and the RAID logical drive state will be Okay after the rebuild operation
is completed.