Cisco WAP571, Руководство администратора

Страница: 57 / 192

Administration
Packet Capture
Cisco WAP571/E Administration Guide 57
3
- wlan1 —VAP0 traffic on Radio 2
- wlan0vap1 to wlan0vap7 —Traffic on the specified VAP on Radio 1.
- wlan1vap1 to wlan1vap 7 —Traffic on the specified VAP on Radio 2.
- wlan0wds0 to wlan0wds3 —Traffic on the specified WDS interface.
- brtrunk —Linux bridge interface in the WAP device.
• Capture Duration —Enter the time duration in seconds for the capture. The
range is from 10 to 3600. The default is 60.
• Max Capture File Size —Enter the maximum allowed size for the capture file
in KB. The range is from 64 to 4096. The default is 1024.
STEP 3
Click Save . The changes are saved to the Startup Configuration.
STEP 4
Click Start Capture .
In Packet File Capture mode, the WAP device stores captured packets in the RAM
file system. Upon activation, the packet capture proceeds until one of these events
occurs:
• The capture time reaches the configured duration.
• The capture file reaches its maximum size.
• The administrator stops the capture.
The Packet Capture Status area of the page shows the status of a packet capture,
if one is active on the WAP device.
• Current Capture Status —Whether packet capture is running or stopped.
• Packet Capture Time —Elapsed capture time.
• Packet Capture File Size —The current capture file size.
Click Refresh to show the latest data from the WAP device.
NOTE
To stop a packet file capture, click Stop Capture .